Packing the Secondary Riser Covers

Place the risers on top of each other, routing them underneath the main riser cover.

Continue routing until you reach the secondary riser cover.

Split the risers so they run parallel to one another.

Position the rear riser at the bottom of the sidewall, ensuring the toggle faces the reserve tray.

Make sure the rear riser lies completely flat before proceeding.

Place the front riser parallel to the rear riser, underneath the secondary riser cover, with the dive loops facing the reserve tray. Ensure it is as flat as possible.

Close the secondary riser cover, making sure it is fully stretched and completely covers both the front and rear risers. Position the binding tape of the secondary riser cover as close as possible to the bottom of the container (the backpack).

Hold the secondary riser cover in place with the sidewall, then close the main riser cover. Insert the pointed tip first. Ensure the magnets align properly and confirm that the secondary riser cover remains fully stretched to maintain optimal aesthetics and proper memory in your EVO2.

Verify riser alignment and riser ramp routing. Make sure the risers run parallel all the way to the riser ramps. Ensure the soft links and canopy lines follow the riser ramps to prevent any canopy lines from being routed to the bottom of the reserve tray.

Repeat the entire process on the opposite side to complete the secondary and main riser cover packing setup.

Place the main deployment bag into the main tray and close the container, completing the pack job.

Verify secondary riser cover alignment. After closing the main tray, check that the secondary riser covers are still correctly positioned to ensure proper coverage and maintain clean aesthetics.